. MAINTENANCE SERVICE PROCEDURE REPLACE FUEL FILTER CARTRIDGE WARNING Prepare a filter wrench 1. Close supply valve (1) of the fuel tank. 2. Set the container to catch the fuel under the filter cartridge. 3. Using a filter wrench, turn filter cartridge (2) counterclockwise to remove it. 4. Clean the filter holder, fill a new filter cartridge with clean fuel, coat the packing surface with engine oil, then install it to the filter holder. 5. When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten a further 1/2 to 3/4 turns. If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel.
If the filter is too loose, fuel will also leak from the packing, so always tighten the correct amount. 6. After replacing filter cartridge (2), loosen air bleed plug (3), and open supply valve (1). 7. Loosen knob (4) (one each on left and right) of the feed pump, and move it up and down to make the fuel overflow until no more bubbles come out from air bleed plug (3). 8. Tighten air bleed plug (3), then push in knob (4) (one each on left and right) of the feed pump, and tighten it. 9. After replacing the filter cartridge, start the engine and check that there is no leakage of fuel from the filter seal surface. If there is any leakage of fuel, check the tightening of the filter cartridge.
If there is still leakage of fuel, follow Step 2 and 3 to remove the filter cartridge, then check the packing surface for damage or foreign material. If any damage or foreign material is found in the packing, replace the cartridge with a new part, then repeat Steps 4 to 9 to install the filter cartridge. Be sure to use both priming pumps to bleed air. If any air remains in the fuel line, it can cause a problem in the fuel system. 4 - 55 Each part is at high temperature a fter the engine has been operated, so never change the filte r immediately after finishing operations. Wait for each part to c ool down before changing it. fuel.
Do not bring fire or sparks near the hen the engine is started after stopping because fuel is used up, if misfirming or black exhaust emission occur, ed air from the fuel line accord . Loosen the air bleed plugs of b oth injection pumps, bleed air by operating both feed pu mps as explained in Steps 6 - 8 above.