. MAINTENANCE SERVICE PROCEDURE CHECK WEAR OF REAR BRAKE DISC WARNING CHECK TIGHTENING PARTS OF TURBOCHARGER Contact your Komatsu distributor to have the tightening portions checked. 4 - 62 Carry out this check when the brake oil temperature is below 60°C (1 40°F). When carrying out the work with two workers, if the retarder control le ver is pulled suddenly, there is danger that the rod of the disc wear measurement gauge may fly out suddenly under hydraulic pressure. Pull the rod out fully, and operate the retarder control lever slowly over a period of approx. 10 seconds. If the disc wear approaches the wear limit, check the condition freque ntly, regardless of the maintenance interval.
In addition, check the retarder capacity carefully. 1. Stop the machine on level ground, set the parking brake valv e lever to the PARKING position, then check that the other brakes are not applied before starting inspection. r e t, c e at e. . conds to apply the brake. s the piston. n s r s e. s (1). R FROM REAR BRAKE (PAGE 4-28)". 2. Remove plug (1) from the rear brake and install the disc wea measurement gauge. When doing this, tighten the nipple fully and pull the rod of th disc wear measurement gauge out fully. If it is not pulled ou there is danger that the rod may fly out under hydrauli pressure when the retarder lever is pulled. Part number for gauge: 561-98-61122 measurement gauge.
When doing this, tighten the nipple fully and pull the rod of th disc wear measurement gauge out fully. If it is not pulled ou 3. Turn the starting switch to the ON position and check that th air pressure gauge is in the green range. 4. If the air pressure is low, start the engine and run the engine 2,000 rpm until the air pressure gauge enters the green rang When it enters the green range, turn the starting switch OFF 5. Operate the retarder control lever slowly over approx. 10 se In this condition, push the gauge rod in slowly until it contact 6. If mark (A) of the disc wear measurement gauge goes i beyond the end face of the case, this means that the disc ha reached the wear limit.
If this happens, please contact your Komatsu distributor fo inspection and maintenance. If the rod is released suddenly after measurement, there i great danger that the rod may fly out under hydraulic pressur Keep the rod held down and let it back slowly. When it reache the end of its stroke, release it. Return the retarder control lever. 7. 8. Remove the disc wear measurement gauge and install plug 9. Bleed all the air from the circuit. For details, see "BLEED AI