. MAINTENANCE SERVICE PROCEDURE time. CHECK WATER PUMP CHECK INJECTION PUMP RACK RUBBER BOOT, REPLACE inside. Tightening torque of cap (1): 22.1 ± 2.45 N · m (2.25 ± 0.25 kgf · m, 16.3 ± 1.8lbft) 4 - 69 EVERY 4000 HOURS SERVIC Carry ou t the EVERY 100 HOURS MAINTENANCE , EVERY 25 0 HOURS MAIN TENANCE, EVER Y 500 HOURS MAINTENANCE, EVERY 1 000 HOURS MAINTENANCE , and E VERY 2000 HOU RS MAINTENAN CE at the same Check f or play in t he p ulley, leakage of grease or water, o r cloggin g of the drain hol e. If any problem is found, contact your Ko matsu distributor fo r disassembly and repair or r eplacement. CHECK AIR COMPRESSOR Ask you r Komats u distribut or to carr y out this work.
CHECK FAN PULLEY AND TENSION PULLEY Check f or play of t he pulley and l eakage o f grease. If any problem is found, please contact your Kom atsu distributor. CHECK VIBRATION DAMPER There is the possibilit y of dr op in the level of the damper f luid and runout of the con cave surface. So, please contact your Ko matsu distributor to inspect or replace. Check t he injection pump rac k ru bber boot for c rack s and o leakage . If any abnormality is found, please contact your Komats distribut or for r eplacement. REPLACE INJECTION PUMP SCREEN FILTE R Remove injection pump cap (1), then replace screen filter (2) wit a new p art.
The side of the scree n filter with the holes is assembled f acing th