eng — OPERATING PAYLOAD METER

. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER 4) After carrying out calibration, operate the dump lever once FLOAT LOWER FLOAT with the dump body empty. 6 - 10 4. Remove the connec tors, remove the screws (top: M4 x 8, rear M4 x 3) of top cover (1) of the payload meter, then remove top cover (1). 5. Remove the nut (M 4) and the band holding the ba ttery. on. Do not wear gloves when carrying out this operati Be careful not to let dirt, dust, or metal particles g et inside the controller. Be carefu controller. l not to drop any nuts or washers inside the 6. Pull the battery con remove them.

nectors up directly from the printboard to rs of the new battery down straight to printboard. , then fix the battery to the payload mete 7. Push the connecto connect them to the 8. Fit the battery band yload mete with the nut (M4) an Check that the batte d washer (flat spring). ry has not moved out of posit 9. Install the top cover 10. Install the payload m eter to its original position on Afte r replacing the batte 1) Turn the starting 2) Press the memo ry data clear switch (CLR) twi ce to delete the dat a from memory. (Th e first time, it will flash , it will light up and then displa y the load.) 3) Carry out calibra Replace the battery with The life of the battery is