eng — TROUBLESHOOTING

. ATTACHMENTS, OPTIONS ARSC (AUTOMATIC RETARDER SPEED CONTROL) WHEN SYSTEM IS NORMAL The code is displayed on the controller LED under the assistant's seat. REMARK If the above code is not displayed when the accelerator pedal is being depressed or not being depressed, it is necessary to adjust the accelerator link. If it is not properly adjusted, the ARSC system will not be able to judge correctly if the accelerator pedal is being depressed or not, so the ARSC may not work normally. 6 - 33 Remedy pattern 1 If the central warning la mp and the ARSC cautio n lamp flash and the buzzer so unds, it mean s that a serious p roblem has occurred in the A RSC system.

Operation of the ARSC system is stopped. Ope rate the brak e pedal or retarde r lever a s necessary to ensure safety. Whe n the system swit ch is turned OFF, the ce ntral warning lamp a nd ARSC cautio n lam p go o ut and the buzzer stop REMARK If the starting switch i s turned ON when the air pressure in the air tank has dropped, failure code "9.2" may be ens, start the engine and raise the air pressure to the normal level, then start again. If the may be displayed. If this happ ens, start the engine and raise the air pressu re to the normal l evel, then st art again.

If the failure code is "9 .3" or "9.4", it shows that there is a failure in t he system switch , so e ven if t he system switch is tur ned OFF, the cen tral warning lamp and A RSC caution lamp w ill flash a nd the b uzzer will so und. Remedy pattern 2 Whe n only the ARSC The ARSC system co ntinues to be actuated, b ut an abnormality ha s occurre d in the Turn the system switc h OFF to stop use of the Whe n the system swit ch is turned OFF, the AR SC caution l amp wil In th e case of patterns 1 and 2 above, turn the system switc h OFF q uickly, st op use of the ARSC and contact your Komatsu distributor fo r repairs.

The set travel speed d isplay is also equipped w ith a self- diagnostic function, and a fa ilure code is displayed on the set tr avel speed displa No. Failure code Detail Method of resetting 1 Abn E1 i ormality Turn the starting switch ON again or turn the system switch ON again. n CPU 2 Abn E2 in ormality Turn the starting switch ON again or turn the system switch ON again. memory No. Code Condition 1 0.0 Whe n accelerator pedal is being depressed ("." is not shown for 0 on the right) 2 0.0. Whe n accelerator pedal is not being depressed ("." is shown for 0 on the right)