. ATTACHMENTS, OPTIONS PMC (POWERTRAIN MANAGEMENT CONTROLLER) AND MOM (MESSAGE FOR OPERATION AND MAINTENANCE) THE PICTURE OF INITIAL CHECK 2 (i3) This picture is displayed after engine is started and before shift lever is changed from neutral position in order to inform operator that departure is acceptable or not. When MOM judges that departure is acceptable, "DEPARTURE OK" is indicated. When MOM judges that departure is not acceptable, "DEPARTURE WAIT" is indicated. THE ORDINARY PICTURE (i4) 6 - 38 Machine is able to be departed even if "DEPARTURE WAIT" is indicated for emergency When engine is started, (i2) is changed to the picture of initial check (i3) automatically.
If you touch LIGHT OFF area i n (i3), then the back light of MOM is turned off and (i3) is tu rned to be dark (i7). It can be used when annoyed by the glare during the driving at night. If the dark picture is touch ed, the back light lights up again. If any controller detects fault, ( i3) is changed to the picture of warning message (i6) auto MOM indicates data of curren number of cycle only when machine. t payload, total payload, and total optional PLM II is installed in the hese data are as follows.
The period that PLM II sends t When PLM II recognizes tha t machine is loading condition, then PLM II starts sending t he data of current payload to MOM and keep sending d machine is changed to dum ata successively until payload meter recognizes that load ing condition is finished or ping condition. completion of loading, MOM's payload display value is fixed until the dumping. mping condition. MOM, please dump, load, and dump again in order to initialize the recognition of When PLM II recognizes the completion of loading, MOM's payload display value is fi When PLM II recognizes du If any data are not indicated in machine condition of PLM II.
(U ntil the current payload, total payload, and total number o f cycle are sent by PLM II, it can happen that the data are not indicated.) f PLM II, see another payload meter operation manual. s of these data or adjust clock, contact your Komatsu distributor. As to details of the operation o When you want to change unit s of these data or adjust clock, contact your Komatsu dist If you touch "LIGHT OFF" area in (i4), then the back light of MOM is turned off and (i4) i s changed to be dark (i7). It can be used when annoyed by the glare during the driving at night. If the dark picture is touched, the back light lights up again.
i4) is changed to the picture of warning message (i6) automatically. If any controller detects fault, ( i4) is changed to the picture of warning message (i6) auto