eng — TROUBLESHOOTING

. ATTACHMENTS, OPTIONS ASR-II (AUTOMATIC SPIN REGULATOR II) METHOD OF DISPLAYING MODEL SELECTION, TIRE LARGE DIAMETER/SMALL DIAMETER, FAILURE CODE the 4. Latest failure code 5. Failure code that occurred immediately before the failure code in 4. 6. Failure code that occurred immediately before the failure code in 5. METHOD OF CLEARING FAILURE CODE When the starting switch is at ON position (when the engine is not started), disconnect the connectors CR1 and CR2 located behind the operator's seat. At this time, " " is displayed on controller LED. When the flashing of " " turns to the lighting up of " " (3 seconds), then failure code is cleared.

REMARK When the ASR is used at the first time, be sure to clear the failure code. Connect the connectors CR1 and CR2 after the clearance. 6 - 44 Remedy pa When only the ASR caution l amp flashes The ASR s ystem continues t o be actuated, but an abnormalit y has occurred in t he system. Stop at the safe place quickly and turn the system switch OFF to s top use of the ASR. When the s ystem switch is tu rned OFF , the ASR caution lamp will go In the case of patterns 1 and 2 above, t urn the system switch OFF quickly , stop use of the ASR and contact your Komatsu di stributor for repair WHEN SYSTEM IS NORMAL The code ( 0.0) is displayed b y the controlle r LED behind the a ssistant's seat.

When the s tarting switch controller L 1. LEDs a 2. Model Code: 7 3. Tire dia 1. LEDs a ll light up 2. Model 3. Tire dia meter (Large/sma urned ON, the codes below are a utomatically displayed in the following order on Code Tire Large/Small B. – Large size (standard) S. – Small size (if equipped)