. OPERATION EXPLANATION OF COMPONENTS between the low idle and GEAR SHIFT LEVER The gear range can be selected with this lever (3) to match the travel conditions. FLOAT position. Set the dump lever to the Position Speed range Max. speed (km/h (MPH)) 5 1st torque converter - 5th direct 36 (22.4) 4 1st torque converter - 4th direct 27 (16.8) 3 1st torque converter - 3rd direct 20 (12.4) L 1st torque converter - 2nd direct 15 (9.3) If the dump body is raised, it is impossible to shift up from 1st. Always lower the dump body when traveling. When operating the shift lever, be sure to set it in position securely.
If the lever is not placed in position properly, the shift position display on the panel may go out and the transmission warning monitor lamp may light up. 3 - 31 ACCELERATOR PEDAL This pedal (2) is used to adjus It ca n control freely the engin tle. throt the full D po sition: osition, the transmission is shifted This is used for normal travel. If th e lever is placed in this p shifted automatically from 2nd (torque converter drive) to 7th (direc t drive) to m atch the travel speed of th e machine. If the dump body is raised, the speed range is fixed at 2nd when the shift lways lower the dump body when ition is 65 km/h (40.4 MPH). The maximum speed in D pos ition is 65 km/h (40.4 MPH).
R po sition: reverse. converter drive. reverse if the dump lever is not at This is used when traveling in This position uses the torque The machine cannot travel in not the FLO AT position before movin g the shift lever to the R position . 5 - L position: The se positions are used in pl aces where it is difficult to travel at high speed, or when t raveling on soft gr ound, or whe n starting the machine off on a slope when it is loaded. They are also used when go ing downhill if it is needed to us e the braking force of the engine. T he speed ranges for each