Komatsu — Viewing Live Sensor Data

Payload Meter III - Section 60 OM6009 8/11 Page 60-6 LOAD DISPLAY AND OPERATOR SWITCHES Total Ton and Total Load Counters PLMIII allows the truck operator to monitor and track the total tons hauled and the number of haul cycles during the shift. This display can be cleared at the beginning of each shift to allow the operator to record how many loads and tons have been hauled during the shift. The lower display on the speedometer/load display is used for payload information. Use the operator switches to scroll to the “PAYLOAD DATA” main level screen, then through the following payload meter information displays:

To view the total ton and total load counters, refer to “Digital Display Operation - Toggling Through Main Level Screens” in Section 32. Follow the flow chart to the desired payload meter information screen. Operator ID Total Shift Tons Shift Load Counter The total ton counter records the number of tons hauled since the last time it was cleared. This display is in 100’s of tons. This display can be cleared at the beginning of each shift to allow the operator to record how many tons have been hauled during the shift. Suspension Pressures and Inclinometer The display holds the operator ID and total shift tons information until the OK position of the operator switch is pressed.

The suspension pressures, inclinometer, and payload displays are based on current sensor inputs. The total load counter records the number of loads hauled since the last time it was cleared. This display can be cleared at the beginning of each shift to allow the operator to record how many loads have been hauled during the shift. Setting the Operator ID The current operator ID number is recorded with each haul cycle. The number can be between 0 and 9999. Clearing the total ton counter or total load counter clears both records. To clear the total ton and total load counter, press the OK position of the operator switch while viewing this screen.

To set the operator ID, use the arrow positions of the operator switches to scroll to the “PAYLOAD DATA” main level screen. Then refer to “Digital Display Operation - Entering Payload Meter Data” in Section 32. Follow the flow chart, substituting your operator ID for the one in the example. Viewing Live Sensor Data The display can also be used to quickly show the current readings from the four suspension pressure sensors and the inclinometer. This can be used during regularly scheduled service periods to check the state of the suspensions. These displays are live and will update as the values change. If no buttons are pressed for 30 seconds, the display will return to normal operation.

The number being entered will be lost and the operator ID returns to the previous number. The live displays cannot be cleared and the OK position of the operator switch will have no effect. The units for the display are controlled by the configuration of the payload meter. If the payload meter is set to display metric units, the pressures will be displayed in tenths of kg/cm 2 . The inclinometer displays whole degrees of incline. Positive incline is truck nose up.