Yanmar — 5.1.3 Color check procedure

5. Inspection and servicing of basic engine parts 5. Inspection and servicing of basic engine parts 5.1 Cylinder block The cylinder block is a thin-skinned, (low-weight), short skirt type with rationally placed ribs. The side walls are save shaped to maximize rigidity for strength and low noise. 5.1.1 Inspection of parts Cap plug 45 mm Make a visual inspection to check for cracks on engines that have frozen up, overturned or otherwise been subjected to undue stress. Perform a color check on any portions that appear to be cracked, and replace the cylinder block if the crack is not repairable.

Cap plug 25 mm Cap plug 30 mm 5.1.2 Cleaning of oil holes Clean all oil holes, making sure that none are clogged up and the cap plugs do not come off. Cap plug 30 mm Color check kit Cap plug 12 mm (main gallery) 5.1.3 Color check procedure (1) Clean the area to be inspected. (2) Color check kit The color check test kit consists of an aerosol cleaner, penetrant and developer. (3) Clean the area to be inspected with the cleaner. Either spray the cleaner on directly and wipe, or wipe the area with a cloth moistened with cleaner. (4) Spray on red penetrant After cleaning, spray on the red penetrant and allow 5-10 minutes for penetration.

Spray on more red penetrant if it dries before it has been able to penetrate. (5) Spray on developer Remove any residual penetrant on the surface after the penetrant has penetrated, and spray on the surface after the penetrant has penetrated, and spray on the developer. If there are any cracks in the surface, red dots or a red line will appear several minutes after the developer dries. Hold the developer 300-400 mm away from the area the surface uniformly. (6) Clean the surface with the cleaner. NOTE: Without fail, read the instructions for the color check kit before use. 104 Quantity Penetrant 1 Developer 2 Cleaner 3