Yanmar — 5.1.5 Cylinder bore measurement

5. Inspection and servicing of basic engine parts 5.1.5 Cylinder bore measurement Especially clean head surface, cylinder bores and oil holes, and check the below items after removing any carbon deposit and bonding agent. (a) Appearance inspection Check if there is any discoloration or crack. If crack is suspected, perform color check. Sufficiently clean the oil holes and check they are not clogged. (b) Cylinder bore and distortion Measure at 20 mm below the crest of the liner, at 20 mm from the bottom end and at the center in two directions A and B as shown in the below figure. Roundness: Roundness is found as follows though it is the simple method.

Measure cylinder diameters of the A direction and the B direction on each section of a, b and c. Roundness is the maximum value among those difference values. Cylindricity: Cylindricity is found as follows though it is the simple method. Measure cylinder diameters of a, b and c sections in the A direction, and calculate the difference in maximum value and minimum value of the measured diameters. In the same way measure and calculate the difference in the B direction. 001494-00E (Cylinder bore) a 20 mm A b B Measure in two directions A and B at points a, b and c. c 20 mm (Cylinder bore measurement positions) Cylindricity is the maximum value between those difference values.

mm 106R1 Item Model Standard Limit Cylinder bore diameter 3YM30 76.000-76.030 76.200 3YM20/2YM15 70.000-70.030 70.200 Cylinder roundness /Inclination 0.01 or less 0.03