6. Fuel injection equipment 6.1.7 Troubleshooting of fuel injection pump Complete repair means not only replacing defective parts, but finding and eliminating the cause of the trouble as well. The cause of the trouble may not necessarily be in the pump itself, but may be in the engine or the fuel system. If the pump is removed prematurely, the true cause of the trouble may never be known. Before removing the pump from the engine, at least go through the basic check points given here. Basic checkpoints Check for breaks or oil leaks throughout the fuel system, from the fuel tank to the nozzle. Check the injection timings for all cylinders. Are they correctly adjusted?
Are they too fast or too slow? Check the nozzle spray. Check the fuel delivery. Is it in good condition? Loosen the fuel pipe connection at the injection pump inlet, and test operate the fuel feed pump. 6.1.8 Major faults and troubleshooting 141 Fault Cause Remedy 1. Engine won’t start Fuel not delivered to injection pump (1) No fuel in the fuel tank. (2) Fuel tank cock is closed. (3) Fuel pipe system is clogged (4) Fuel filter element is clogged (5) Air is sucked into the fuel due to defective connections in the piping from the fuel tank to the fuel pump. (6) Defective valve contact of feed pump (7) Piston spring of feed pump is broken.
(8) Inter-spindle or tappets of feed pump are stuck Re-supply Open Clean Disassemble and clean, or replace element Repair Repair or replace Replace Repair or replace Fuel delivered to injection pump. (1) Defective connection of control lever and accel rod of injection pump. (2) Plunger is worn out or stuck. (3) Delivery valve is stuck (4) Control rack doesn’t move (5) Injection pump coupling is damaged, or the key is broken. Repair or adjust Repair or replace Repair or replace Repair or replace Replace Nozzle doesn’t work. (1) Nozzle valve doesn’t open or close normally (2) Nozzle seat is defective. (3) Case nut is loose.
(4) Injection nozzle starting pressure is too low (5) Nozzle spring is broken. (6) Fuel oil filter is clogged. (7) Excessive oil leaks from the nozzle sliding area. Repair or replace Repair or replace Inspect and tighten Adjust Replace Repair or replace Replace the nozzle assembly Injection timing is defective. (1) Injection timing is retarded due to failure of the coupling. (2) Camshaft is excessively worn. (3) Roller guide incorrectly adjusted or excessively worn. (4) Plunger is excessively worn. Adjust Replace camshaft Adjust or replace Replace plunger assembly