9. Cooling water system 9.2.3 Seawater pump Inspection (Refer to 2.2.4(5).) (1) Inspect the rubber impeller, checking for splitting around the outside, damage or cracks, and replace if necessary. V-pulley Shaft Retaining ring Ball bearing Retaining ring Ball bearing Spacer Plate O-ring Oil seal O-ring Cover Pump body (Seawater pump) (2) Inspect the oil seal and replace if it is damaged. Also replace the oil seal if there is considerable water leakage during operation. (3) Make sure the ball bearings rotate smoothly. Replace if there is excessive play. 160 Cooling water leakage less than 3 cm3/h