12. Electrical System 12.2 Battery The new type instrument panels are applied for 3YM30 series engines. The features are compactness, waterproof and independence from pulse by ring gear teeth number. The engine speed, indicated with the instrument panel is activated by the pulse from flywheel ring gear. The engine speed with new panel is activated by alternator B terminal pulse. (1) Battery capacity (2) Battery cable Wiring must be performed with the specified electric wire. Thick, short wiring should be used to connect the battery to the starter. Using wire other than that specified may cause troubles.
The overall length of the wire between the battery (+) terminal and the starter (B) terminal, and between the battery (-) terminal and the starter (E) terminal, should be determined according to the following table. Note : Excessive resistance in the key switch circuit (between the battery and start [S] terminals) can cause improper pinion engagement. To prevent this, follow the wiring diagram carefully. 185 Battery capacity (5 hours rating) 12V-64 AH or more (type 95D31L equivalent) Voltage system Allowable wiring voltage drop Conductor cross section area Allowable overall length 12 V 0.2 V or less/100A 20 mm2 Up to 2.5 m 40 mm2 Up to 5 m