Yanmar — 12.3.4 Wiring diameter of a starting motor

12. Electrical System (2) Structure When the starting switch is turned on, a magnet switch takes a voltage, and a pinion projects. The pinion engages with the ring gear of a engine, and the engine is started. Torsion Spring Magnetic Switch Center Bracket (A) Shift Lever Brush Gear Case Pinion Shaft Pinion Armature Yoke Center Bracket (P) Internal Gear Planet Gear Rear Cover 12.3.4 Wiring diameter of a starting motor 1) When a starting switch is turned on, a magnet switch is charged, and a moving core is absorbed, and a pinion clutch is moved forward through a lever, and the pinion engages with a ring gear.

2) When the pinion engages the ring gear, because a main contact point is closed and the main electric current flows and a pull coil is short- circuited by the main contact point and it stops being charged with electricity, the pinion is kept at the position by a holding coil during the start. 3) When the starting switch is turned off, the main contact point becomes open, and the pinion clutch is returned to the stop position by a return spring. Starting switch Magnetic switch S B M Mag Mag Battery Starting motor 188