Yanmar — 2.2.7 Inspection every 1,000 hours or four years

2. Inspection and adjustment 2) Spray pattern inspection After adjustment to the specified valve opening pressure, use a nozzle tester and check the spray pattern and seat oil-tightness. a) Seat oil tightness check After injecting a few times, increase the pressure gradually. Hold the pressure for about 5 seconds at a little before the valve opening pressure of 1.96 MPa (20 kgf/cm 2 ), and check to see that oil does not drip from the tip end of the nozzle. If extreme oil leak from the overflow joint exists during injection by the nozzle tester, check after retightening. If much oil is leaking, replace the nozzle assembly.

b) Spray and injection states Operate the nozzle tester lever at a rate of once or twice a second and check no abnormal injection. If normal injection as shown below cannot be obtained, replace the fuel injection valve. No extreme difference in angle( Θ ) Finely atomized spray Excellent spray departure = 5 10 (Abnormal spray pattern) (Normal spray pattern) 3) Nozzle valve sliding test Wash the nozzle valve in clean fuel oil. Place the nozzle body vertically and insert the nozzle into the body to about 1/3 of its length. The valve is normal if it smoothly falls by its own weight into the body.

In case of a new nozzle, remove the seal peel, and immerse it in clean diesel oil or the like to clean the inner and outer surfaces and to thoroughly remove rust-preventive oil before using the nozzle. Note that a new nozzle is coated with rust-preventive oil and is pasted with the seal peel to shut off outer air. (Nozzle valve sliding check by gravity) 40