Yanmar — 2.6.3 Check points and precautions during running

2. Inspection and adjustment 2.6.3 Check points and precautions during running 47 Step Item Instructions Precautions 1 Checks before operation 1) Make sure that the sea cock is open. 2) Make sure there is enough lube oil and (fresh) cooling water. 3) Operate the remote control handle and check if the device connected to the engine works property. 3) Lamp should go off when engine is running. 2 No load operation; warm up operation 1) When the lube oil temperature is raised to allow the engine to start, the pilot lamp goes off. 2) When the engine is started, check the following: • There is no leakage of water, fuel and lube oil. • Exhaust gas does not leak when the engine is started.

• here is no abnormal indication on the instrument panel. • There is no abnormality in cooling water discharge, engine vibration. or engine sound. 3) To warm up the engine, operate at low speed for about 5 minutes, then raise the speed to the rated speed and then to max. speed. 2) • Fit leaks if any. • Check the intake/ exhaust valves, fuel injection nozzle and cylinder head. 3) Do not raise the engine speed abruptly. 3 Cruising (load) operation 1) Do not operate the engine at full load yet, but raise the speed gradually for about 10 minutes until it reaches the rated speed. 2) Make sure that exhaust gas color and temperature are normal.

3) Check the instrument panel and see if the water temperature and oil pressure are normal. 4 Stopping the engine 1) Before stopping the engine, operate it at 650-700 min-1 for about 5 minutes. 2) Raise engine speed to 1,800 min-1 jut before stopping the engine and idle the engine for about 3-4 seconds. 1) Stopping the engine suddenly during high speed operation increases the temperature of engine parts. 2) This procedure prevents carbon from being deposited on the valve seats, etc. 5 Checks after stop- ping the engine 1) Check again for water and oil leaks. 2) Make sure that no nuts and bolts are loose. 3) Close the sea cock and fuel cocks.

4) When the temperature is expected to fall below freezing, drain the seawater. 5) Turn off the battery switch. 1) Check the oil seal area. 2) Especially the engine installation bolts. 4) Drain from the seawater pump.