Maintenance - Section 40 OM4039 Page 40-10 Lubrication and Service 250 HOURS SERVICE (continued) 6. HYDRAULIC TANK BREATHERS - Remove breathers, disassemble breathers remove filter element, clean in solvent. Dry with air pressure and reassemble then reinstall. 7. DIFFERENTIAL CASE - Check oil level. Use lube key “B”. 8. DIFFERENTIAL CASE BREATHER - Remove breather. Wash to flush out the dirt from inside. Reinstall after cleaning. 9. FINAL DRIVE CASE - Check oil level in R.H. and L.H. case. Use lube key “B”. 10. DRIVE SHAFTS - Inspect drive shafts for any abnormalities: loose joints, worn splines or bearings, unusual vibration of shaft. Refer to Section F, Drivelines and Adapter.
Notify the proper maintenance personnel, if any discrep- ancies are found. Use lube key “D” chart. 11. PARKING BRAKE - Measure brake pad for proper wear and thickness. Refer to Section J, Brake System, Brake Circuit Checkout And Adjustment, for proper inspection, procedures and too ls. 12. CAB AIR FILTER (Outside) - Inspect and clean or replace filter element. Refer to Section N, Fil- ter Maintenance for procedure. (In extremely dusty conditions, more frequent maintenance may be required.) 13. HEATER/AIR CONDITIONER FILTER (Inside) -Inspect and clean filter as necessary. Refer to Service Manual, Section N, Filter Maintenance for procedure. COMMENTS CHECKED INITIALS