Maintenance - Section 40 OM4039 Page 40-14 Lubrication and Service EVERY 5000 HOUR SERVICE Maintenance for every 250, 500 and 1000 hours should also be carried out at this time. Truck Serial Number ________________________ Site Unit Number ____________________________ Date: __________ Hour Meter _________________ Name of Service Person ______________________ 1. ENGINE DRIVELINE ADAPTER Inspect driveline adapter splines, rubber damp- ers for cracks or separation on rubber surfaces, and bearings. If any defects are noted, repair as required. Refer to Service Manual, Section C for repair procedures. 2.
FRONT AND REAR DRIVESHAFTS If truck is equipped with driveshaft universal joints that DO NOT have grease fittings, inspect both front and rear driveshafts for binding, wear, vibration, or damage to the driveshaft assem- bly. If U-joint damage or roughness is noted, BOTH U-joints on a given shaft should be replaced. Refer to Service Manual, Section F for replacement procedures. 3. FRONT SUSPENSIONS Drain Front suspension oil. Inspect upper flange internal bearing. Replace worn parts. Refill sus- pensions with clean oil and recharge with nitro- gen. Refer to Service Manual, Section H for instructions and WARNINGS when servicing suspensions. 4.
FRONT WHEEL BEARINGS Check front wheel bearing adjustment. Refer to Service Manual, Section G, Front Wheel Hub Bearing Adjustment. 5. RADIATOR Inspect air-to-air aftercooler for damage. After- cooler damage may result in air leaks causing reduced engine performance due to low boost pressure. Whistling noise due to air leakage may also be present if aftercooler is cracked. COMMENTS CHECKED INITIALS