OM4039 Maintenance - Section 40 Lubrication and Service Page 40-25 Standard clearance: Total for both clearances = 1.6 ± 0.08 mm. (0.063 ± 0.003 in.) when pushed to one side; or 0.8 mm each for both sides. 5. After adjusting, return capscrew (2) to a position where capscrew retainer (3) stops it from turn- ing. Refer to Shop Manual, Section J, Brake System, for specific disassembly, repair, or replacement procedures for the parking brake assembly. 4. After adjusting the pad clearance, actuating stroke “a” (Figure 40-18) of the rod should be measured and adjusted to approximately 50 mm (1.97 in). (Figure 40-20) FIGURE 40-18. ARM ADJUSTMENT 1. Slack Adjuster 2. Capscrew 3. Capscrew Retainer 4.
50 mm (1.97 in.) 1. Adjustment Plug 2. Measuring Rod FIGURE 40-19. ADJUSTMENT CLEARANCE 1. Feeler Gauge 2. Adjustment Plug FIGURE 40-20. ADJUSTING CLEARANCE