OM1202 Introduction - Section 12 Standard Charts and Tables Page 12-5 The recommended coating materials such as adhesives, gasket sealants and greases used for disassembly and assembly are listed below. : SEALANTS AND ADHESIVES Nomenclature Code Part Number Applications Adhesives LT-1A TB1521 Used to apply rubber pads, rubber gaskets and cork plugs. LT-1B 790-129-9050 Used to apply resin, rubber, metallic and non-metallic parts when a fast, strong seal is needed. LT-2 VE7533 Preventing bolts, nuts and plugs from loosening and leaking oil. LT-3 (2 part epoxy) Used as adhesive or sealant for metal, glass and plastic. Liquid Gasket LG-1 Used with gaskets and packings to increase sealing effect.
LG-3 1400266H1 Heat-resistant gasket for precombustion chambers and exhaust piping. LG-4 1400265H1 Used by itself on mounting surfaces on the final drive and transmission cases. Thickness after tightening: 0.07-0.08 mm (0.0027-0.0032 in) LG-5 790-129-9080 Used by itself to seal grease fittings, tapered screw fittings and tapered screw fittings in hydraulic circuits of less than 50 mm (2 in) in diameter. LG-6 TB1215 Silicon Rubber - Oil pan, final drive case LG-7 TB1207C Silicon Rubber - Oil pan, flywheel housing Molybdenum disulphide lubricant LM-P 09940-00040 Applied to bearings and tapered shafts to facilitate press-fitting and to prevent sticking, burning or rusting.
Grease G2-LI SYG2-400LI-A General purpose - Applied to bearings, sliding parts and oil seals for lubrication, rust prevention and facilitation of assembly. PART NUMBERS Three Bond Komatsu TB1374 VE7533 TB1521 790-129-9030 TB1104 1400265H1 TB1107 1400266H1 TB1110 790-129-9080