Komatsu — AFTER ENGINE HAS STARTED

OM3042 After 1. 2. With foot pedal Move and lever Set shift lever (2) to the D position, and gradually raise the engine speed to 1240 rpm. 7. Insure headlights, worklights and taillights are in proper working order. Good visibility may pre- vent an accident. Check operation of windshield wiper and washer. Check that the machine does not move. 8. When truck body is in dump position, do not allow anyone beneath it, unless body-up retain- ing device is in place. Operation - Section 30 Page 30-7 TARTED 4. Check parking brake capacity. operate engine at , coolant temperature • With the machine on flat ground, check that the l (green) range. air pressure gauge is indicating NORMAL (green) range.

ir pressure gauge is range. • Move the parking brake valve lever to the miliar with steering, PARKING (LOCKED) ontrols. position. Move the shift lever to any position other than N, and check that the y checks, if actuation central warning lamp brake, or emergency flashes. appear normal, shut • Set shift lever to the D position, and gradually and notify mainte- raise the engine speed to 1770 rpm. Check that the machine does not move. If machine moves, circuit in question is notify maintenance personnel to adjust parking brake. Do not operate truck until parking brake is fully operational. g in extreme right and 5. Check for normal actuation of the emer- gency brake.

ctuation of the foot • With the machine on flat ground, verify the air pressure gauge is indicating NORMAL (green) range. • Move the emergency brake lever to the BRAKE (UNLOCKED) position. • Set shift lever to the D position, and gradually raise the engine speed to full throttle. Check that the machine does not move. If machine moves, notify maintenance oes not move. personnel immediately to repair brakes. ation of the retarder. Do not operate truck until emergency brake is fully operational. t ground, pull retarder