Komatsu — To Raise dump body:

OM3042 Operation - Section 30 Operating Instructions Page 30-11 PASSING 1. Do not pass another truck on a hill or blind curve! To Raise dump body: 2. Before passing, make sure the road ahead is clear. If a disabled truck is blocking your lane, slow down and pass with extreme caution. The dumping of very large rocks (10% of payload, or greater) or sticky material (loads that do not flow freely from the body) may allow the material to move too fast and cause the body to move RAPIDLY and SUDDENLY. This sudden move- ment may jolt the truck violently and cause pos- sible injury to the operator, and/or damage to the hoist cylinders, frame, and/or body hinge pins.

If it is necessary to dump this kind of material, refer to the CAUTION in the following procedure: 3. Use only the areas designated for passing. DUMPING 1. Pull into dump area with extreme caution. Make sure area is clear of persons and obstructions, including overhead utility lines. Obey signals directed by the spotter, if present. Avoid unstable areas. Stay a safe distance from edge of dump area. Position truck on a solid, level surface before dumping. lever. As body raises, the truck Center of Gravity (CG) will move. TRUCK MUST BE ON LEVEL SUR- FACE to prevent tipping / rolling! 2. Carefully maneuver truck into dump position.

When backing truck into dump position, use only the foot-operated brake pedal to stop and hold truck. 3. When in dump position, place transmission range selector at the NEUTRAL position, and apply the park brake lever/switch. has cleared body. 6. When the dump body rises to the set position (adjusted position of body positioner) dump lever returns to the HOLD posi- tion. If desired to raise the body further, move dump lever to raise position and dump will rise. If dump lever is released, lever will return to HOLD position. Dump body will stop in that position. 7. After material being dumped clears body, lower body to frame. dump lever up to th SE position and releas r.

se engine RPM to acce e hoist speed. Refer t CAUTION below. Whe y is near the maximu le, reduce engine RPM on the accelerator pe to the hydraulic system e e l- o n m (reduce foot pres- dal) to reduce shock and hoist cylinders. r sticky material as , slowly accelerate When the material ver to HOLD posi- ntinue moving and dure until material ng very large rocks o d in WARNING above RPM to raise body. move, move hoist le material does not co dy, repeat this proce