microsoft — HG130 SM인쇄용

System pressure has been set before leaving factory, alteration while used is not allowed. Working principles are as follow: 1 Service brake Service brake is using for speed control and pulling up during working and traveling. The principles of this system are: engine starts and drives double pump to work, prefill valve fulfills hydraulic oil into 2 accumulators. And after that the charge pressure of accumulators reaches rated value, prefill valve will stop charging, and hydraulic oil flows into oil tank.

When grader needs to decelerate, step on brake pedal, and it’ll connect to brake oil support oil-way, both prefill valve and accumulators will feed oil to pedal valve and then pass to brake bridge. Brake oil enters into the brake and oil pressure oppress release spring, enmesh active friction plate and slave friction plate and integrate rotary drive hub with still bridge, means to stop drive hub from rolling to pull down grader. After the pressure of brake reaches set value, pedal valve will stop to feed oil to brake to protect it. Also when loosen pedal, pedal valve will stop to feed oil to brake, and oil in brake will flow back to tank through brake valve, thus decelerate brake stopped.

When grader needs to stop, please step on brake pedal to make pedal connected to brake oil-way, and then press T1 brake switch to control gear selection to make gearbox unpowered, videlicet as cut off the power to stop machine. Brake pedal valve is a proportional servo valve, it’ll control oil supply value according to the range of pedal been trod. Accumulators’s role is to support 6 more steps on brake pedal after engine stopped. According to pictures above, this system is comprised of duplicate gear pump, prefill valve, accumulators, pedal brake valve, pressure-control switch, tube and joint etc.

2 Parking brake Hand braking is mainly used for parking safety even when driver leaves the cab. Hand brake uses the type of caliper disc-flexible shaft control. Brake disc connected to gearbox output shaft, drum brake fasten to gearbox, so when tensioning hand brake, the tension will pass to brake crank through flexshaft, and to skid drive shaft to stop machine. This system suitable for use within 15% parking gradient. 20-81