Yamaha YFM7FGPW — PERIODIC MAINTENANCE AND MINOR REPAIR

8 If a torque wrench is not available when installing a spark plug, a good estimate of the correct torque is 1/4–1/2 turn past finger tight. However, the spark plug should be tightened to the specified torque as EBU27460 Engine oil and oil filter cartridge The engine oil level should be checked before each ride. In addition, the oil must be changed and the oil filter cartridge replaced at the intervals spec- ified in the periodic maintenance and lubrication chart. To check the engine oil level 1. Place the ATV on a level surface. 2. Check the engine oil level on a cold engine.

If the engine was started before checking the oil level, be sure to warm up the engine sufficiently, and then wait at least 10 minutes until the oil settles 3. Remove panel F. (See page 8-8.) 4. Install the spark plug cap. for an accurate reading. soon as possible. NOTE: NOTE: 8-22 2. Clean the surface of the spark plug gasket and its mating surface, and then wipe off any grime from the spark plug threads. 3. Install the spark plug with the spark plug wrench, and then tighten it to the specified torque. Tightening torque: Spark plug: 12.5 Nm (1.25 m·kgf, 9.0 ft·lbf) 1. Spark plug gap