4. Install the oil level check bolt and oil filler bolt, and then tighten them to the specified torques. To change the final gear oil 1. Place the ATV on a level surface. 2. Place an oil pan under the final gear case to collect the used oil. Tightening torques: Final gear oil level check bolt: 10 Nm (1.0 m·kgf, 7.2 ft·lbf) Final gear oil filler bolt: 23 Nm (2.3 m·kgf, 17 ft·lbf) 1. Final gear oil filler bolt 8-27 The oil level should be at the brim of the check 3. If the oil is below the brim of the check hole, remove the final gear oil filler bolt, and then add sufficient oil of the recommended type to raise it to the correct level. 1. Final gear oil 2. Final gear oil level check bolt 3.
Correct oil level NOTE: hole. 8