3. ARM IN OPERATION 3. ARM IN OPERATION ARM CYLINDER BUCKET CYLINDER BOOM CYLINDER SWING MOTOR ps1 ps2 T3 T1 T2 T4 TRAVEL MOTOR A1 A2 FRONT PUMP REAR PUMP PILOT PUMP HYDRAULIC TANK 480A3HC12 When the LH control lever is pulled back, the arm spools in the main control valve are moved the to roll in position by the pilot oil pressure (pa5, pa9) from the remote control valve. The oil from the A1 and A2 pump flows into the main control valve and then goes to the large chamber of arm cylinder. At the same time, the oil from small chamber of arm cylinder returns to the hydraulic oil tank through the arm 1 spool in the main control valve. When this happens, the arm rolls in.
The excessive pressure in the arm cylinder head side is prevented by relief valve. The cavitation which will happen to the head side of the arm cylinder is also prevented by the make- up valve in the main control valve. 3-16 3-16 Anti-drift valve Relief valve A5 pb5 ARM 1 pa5 B4 A4 pb4 pa4 A3 B3 pb3 B2 pa3 A2 Make up valve OPTION BOOM 2 pb2 SWING DR3 pa2 B1 pc6 TRAVEL(LH A1 pb1 pa1 TRAVEL(RH) TRAVEL STRAIGHT pr1 P1 PSPT PP PA PH PS SWING TRAVEL( RH) TRAVEL(LH TRAVEL STRAIGHT A6 pb6 pa6 ) P3 P2