Kaiyi BR380JG-1E0 — CRUSHER TOOTH TIP ADJUSTMENT SYSTEM

10 Structure, function and maintenance standard SEN01354-00 Function Revolution angle sensor (3) senses tooth moving distance (b) through swing jaw (8), toggle plate (7), fixing link (6), and rod (5). The controller operate lock cylinder (4) so that tooth clearance (a) set by the machine monitor will be obtained. Crusher clearance adjustment mode 1. Manual adjustment When measuring and adjusting the tooth clear- ance simultaneously, adjust it in the "manual mode". a For the operation of the machine monitor, see "Machine monitor system", Inspec- tion mode: Manual (M). 2.

Semiautomatic adjustment When adjusting the tooth clearance by setting a target moving distance, adjust it in the "semi- automatic mode". a For the operation of the machine monitor, see "Machine monitor system", Inspec- tion mode: Semiautomatic (S). 3. Automatic adjustment When adjusting the tooth clearance by setting a target tooth clearance, adjust it in the "auto- matic mode". a For the operation of the machine monitor, see "Machine monitor system", Inspec- tion mode: Automatic (A).

Judgment of slip of lock cylinder The crusher angle is measured at the moment when the inspection mode is changed last to another mode or when the starting switch is turned from the OFF position to the ON position. If the sensor angle increases more than 2° in the tooth clearance opening direction from this crusher angle, it is judged that the lock cylinder has slipped. BR380JG-1E0 15