10 Structure, function and maintenance standard SEN01355-00 Operation of system 1 Starting engine Stopping engine q When detecting that the starting switch is set to the “STOP” position, the engine controller cuts the signal of the supply pump drive solenoid to stop the engine. q When the starting switch is turned to the START position, the starting signal flows to the starting motor. Then, the starting motor turns to start the engine. When it happens, the engine controller checks the signal voltage from the fuel control dial and sets the engine speed to the speed set by the fuel control dial.
Engine speed control q The fuel control dial sends a signal voltage cor- responding to the rotation angle to the engine controller. The engine controller sends a driving signal to the supply pump depending on the signal volt- age to control the fuel injection pump, and eventually controls the engine speed. BR380JG-1E0 3