Kaiyi BR380JG-1E0 — ELECTRONIC CONTROL SYSTEM

10 Structure, function and maintenance standard SEN01355-00 1) Automatic engine warm-up function q After the engine is started, if the engine coolant temperature is low, the engine speed is raised automatically to warm up the engine. Coolant temperature: Below 30°C Engine speed: Max. 1,200 rpm Engine speed: 1,200 rpm Operating condition (All of following conditions) Operated Reset Engine speed: Any level 2) Overheat prevention function q This function reduces the pump load and engine speed when coolant or hydraulic oil temperature is too high to protect the engine and hydraulic components from overheating.

q This function starts when coolant temperature or hydraulic oil temperature reaches 100°C. BR380JG-1E0 23 Resetting condition (Any one of following conditions) Auto Coolant temperature: Min. 30°C Automatic engine warm-up operation time: Min. 10 minutes Manual Fuel control dial: Kept at 70% of full level or above for 3 sec. or longer Operating condition Operation/Remedy Resetting condition Coolant temperature: Min. 100°C or Hydraulic oil temperature: Min. 100°C Working mode: each mode Engine speed: Kept as is. Reduce pump delivery. Coolant temperature, hydraulic oil temperature: Below 100°C Under above condition, controller is set to condi- tion before operation of function.

(Automatic reset) Operating condition Operation/Remedy Resetting condition Coolant temperature: Min. 102°C or Hydraulic oil temperature: Min. 102° Working mode: each mode Engine speed: Kept as is. Monitor alarm lamp: Lights up Reduce pump delivery. Coolant temperature, hydraulic oil temperature: Below 102°C Under above condition, controller is set to condi- tion before operation of function. (Automatic reset) Operating condition Operation/Remedy Resetting condition Coolant temperature: Min. 105°C or Hydraulic oil temperature: Min. 105°C Working mode: each mode Engine speed: Low idle Monitor alarm lamp: Lights up Alarm buzzer: Sounds Coolant temperature, hydraulic oil temperature:

Below 105°C Fuel control dial: Return to low idle position once. Under above condition, controller is set to condi- tion before operation of function. (Manual reset)