20 Standard value table SEN02288-00 BR380JG-1E0 7 Cate gory Discharge amount of main piston pump (each 1 pump) Piston pump performance Pump speed: At 2050 rpm, PC current 310 mA Test pump dis- Discharge pres- Standard value for Judgement stan- Check Average pressure charge pressure sure of other pump discharge amount dard lower limit Q point (MPa {kg/cm2}) (MPa {kg/cm2}) (MPa {kg/cm2}) Q (l/min.) (l/min.) As P1 + P2 P1 P2 See graph See graph desired 2 a As far as possible, bring pump discharge pressures; P1 and P2 as close as possible to the average pressure when measuring. The error is large near the point where the graph curves, so avoid measuring at this point.
a When measuring with the pump mounted on the machine, if it is impossible to set the engine speed to the specified speed with the fuel control dial, take the pump discharge amount and the engine speed at the point of measurement and use them as a base for calculating the pump discharge amount at the specified speed. Check point Test pump dis- charge pressure (MPa {kg/cm2}) Discharge pres- sure of other pump (MPa {kg/cm2}) Average pre (MPa {kg/c Standard value for ssure discharge amount m2}) Q (l/min.) Judgement stan- dard lower limit Q (l/min.) As desired P1 P2 P1 + P 2 2 See graph See graph