30 Testing and adjusting SEN02303-00 Adjusting valve clearance 1 4. Rotate the crankshaft forward with gear C1 and set wide slit (b) of the rotation sensor ring to projection top (a) of front cover. a Projection top (a) must be within the range of wide slit (b) when it is seen from the fan side. a If you can see the yellow marks of projec- tion top (a) and wide slit (b), you may set them to each other. a Measuring tools for valve clearance k Stop the machine on a level ground. a Measure the valve clearance under the follow- ing condition. k When the crankshaft is set as above, the piston in the No. 1 or No. 6 cylinder is not set to the compression top dead center (TDC). Take care.
q Engine coolant temperature: Normal tem- perature 1. Open the engine hood and remove the bracket for the fan guard and engine step. 2. Remove cylinder head cover (1). a Since the breather connector on the rear side of the cylinder head cover is con- nected to the flywheel housing through the O-ring, pull it together with the cylinder head cover. 5. Check the movement of the rocker arm of the No. 1 cylinder to judge the valve to be adjusted. a If you can move the rocker arms of air intake valves (IN) with the hand by the valve clearance, adjust the valves marked with Q in the valve arrangement drawing.
a If you can move the rocker arms of exhaust valves (EX) with the hand by the valve clearance, adjust the valves marked with q in the valve arrangement drawing. a Valve arrangement drawing 3. Remove plug (2) from the top of the starting motor and insert gear C1 . BR380JG-1E0 9 Symbol Part No. Part name C 1 795-799-1131 Gear 2 Commercially available Clearance gauge