SEN01344-00 00 Index and foreword Connectors newly used for Tier 3 engines 1. Slide lock type (FRAMATOME-3, FRAMATOME-2) 2. Pull lock type (PACKARD-2) q 107 – 170, 12V140 engine q 107 – 170, 12V140 engines q Various pressure sensors and NE speed sensor Examples) Intake air pressure in intake manifold: PIM (125, 170, 12V140 engines) Oil pressure sensor: POIL (125, 170, 12V140 engines) Oil pressure switch (107, 114 engines) Ne speed sensor of flywheel housing: NE (107 – 170, 12V140 engines) Ambient pressure sensor: PAMB (125, 170, 12V140 engines) q Various temperature sensors Example) Intake air temperature sensor in intake manifold: TIM Fuel temperature sensor: TFUEL Oil temperature sensor:
TOIL Coolant temperature sensor: TWTR, etc. Disconnect the connector by pulling lock (B) (on the wiring harness side) of connec- tor (2) outward. Disconnect connector (1) according to the fol- lowing procedure. 1) Slide lock (L1) to the right. 2) While pressing lock (L2), pull out connec- tor (1) toward you. a Even if lock (L2) is pressed, connec- tor (1) cannot be pulled out toward you, if part A does not float. In this case, float part A with a small screw- driver while press lock (L2), and then pull out connector (1) toward you. 20 BR380JG-1E0