SEN02089-01 40 Troubleshooting Classification and procedures of troubleshooting 1 Classification for troubleshooting Procedure for troubleshooting If a phenomenon looking like a trouble occurs in the machine, select a proper troubleshooting No. according to the following procedure, and then go to the corresponding troubleshooting section. 1. Procedure for troubleshooting to be taken when user code and failure code are displayed on machine monitor: If a user code and a failure code are displayed on the machine monitor, carry out the troubleshooting for the corresponding “ Display of code ” according to the displayed failure code. 2.
When electrical system failure code or mechanical system failure code is recorded in fault his- tory: If a user code and a failure code are not displayed on the machine monitor, check for a mechanical sys- tem failure code and an electrical system failure code with the fault history function of the machine mon- itor. If a failure code is recorded, carry out troubleshooting for the corresponding “ Display of code ” accord- ing to that code. a If an electrical system failure code is recorded, delete all the codes and reproduce them, and then see if the trouble is still detected. a A failure code of the mechanical system cannot be deleted.
a If a trouble is displayed in the air conditioner fault history or heater fault history by the fault history function, carry out the corresponding troubleshooting in “ E mode 3. When user code or failure code is not displayed and no failure code is recorded in fault history: If a user code or a failure code is not displayed on the machine monitor and no failure code is recorded in the fault history, a trouble that the machine cannot find out by itself may have occurred in the electrical system or hydraulic and mechanical system.
In this case, check the phenomenon looking like a trouble again and select the same phenomenon from the table of “Phenomena looking like troubles and troubleshooting Nos.”, and then carry out trouble- shooting corresponding to that phenomenon in the “ E mode H mode ”, or “ S mode 6 BR380JG-1E0 Type Contents Display of code Troubleshooting by failure code E mode Troubleshooting for electrical system H mode Troubleshooting for hydraulic and mechanical system S mode Troubleshooting for engine