SEN02090-00 40 Troubleshooting Failure code [7RC1KB] Short circuit conveyor ON switch 1 4 BR380JG-1E0 User code Failure code Trouble Short circuit conveyor ON switch (Work equipment and pump controller (work equipment control) system) — 7RC1KB Contents of trouble • Input signal circuit for the conveyor ON switch is closed (connected to ground circuit) within 1 sec- ond after the engine starting switch ON. Action of controller • Even if cause of failure disappears, system does not reset itself until engine starting switch is turned OFF • Turns all the output OFF for 1 second after turning the engine starting switch ON.
• Output to the conveyor normal rotation EPC solenoid does not turn ON even if the conveyor ON switch is pressed. Problem that appears on machine • Primary conveyor does not work even if the conveyor ON switch is pressed. • Horn sounds (three intermittent sounding) upon detecting a failure. Related information • Input state (ON/OFF) from the conveyor ON switch can be checked with the monitoring function (Code: 25000, Switch Input 0). • The failure history is recorded.
Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective conveyor ON switch aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. B71A (male) Conveyor ON switch Resistance Between (1) and (2) ON Max. 1 z OFF Min. 1 Mz 2 Grounding fault in wir- ing harness (Contact with ground circuit) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between C02 (female) (15) – B71 (female) (2) and chassis ground Resistance Min.
1 Mz 3 Defective work equip- ment and pump con- troller aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. C02 (female) Conveyor ON switch Resistance Between (15) and chas- sis ground ON Max.1 z OFF min.1 Mz