Kaiyi BR380JG-1E0 — FAILURE CODE [7RFAKZ] DISCONNECTION OR SHORT CIRCUIT IN ENGINE STOP RELAY

SEN02091-00 40 Troubleshooting Failure code [7RFAKZ] Disconnection or short circuit in engine stop relay 1 6 BR380JG-1E0 User code Failure code Trouble Disconnection or short circuit in engine stop relay (Work equipment and pump controller (work equipment control) system) — 7RFAKZ Contents of trouble • When the engine stop relay is not driven, disconnection of the circuit or ground short circuit is detected. Action of controller • Does not detect CAN communication error of the engine controller. • If cause of failure disappears, system resets itself.

Problem that appears on machine • The engine does not stop even if engine stop switch or All Stop switch of radio and wired remote control system is pressed. • Horn sounds (three intermittent sounding) upon detecting a failure. Related information • The drive state (ON/OFF) of the engine stop relay can be checked with the monitoring function (Code: 25601, Relay Drive 0). • This failure code is generated when the primary (coil side) of engine stop relay has failed. A failure of the secondary (contact side) cannot be detected with this code. • The failure history is recorded.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective fuse No. 7 If the fuse No. 7 is blown, the circuit probably has a grounding fault, etc. (See cause 4.) 2 Defective engine stop relay (Internal discon- nection or grounding) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. R19 (male) Resistance Between (1) and (2) 100 – 500 z 3 Disconnection in wiring harness (Disconnec- tion or defective con- tact in connector) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON.

Wiring harness between C02 (female) (8) – R19 (female) (2) Resistance Max. 1 z Wiring harness between R19 (female) (1) – B28 No. 7 Resistance Max. 1 z 4 Grounding fault in wir- ing harness (Contact with ground circuit) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between C02 (female) (8) – R19 (female) (2) and chassis ground Resistance Min. 1 Mz Wiring harness between R19 (female) (1) – B28 No. 7 and chassis ground Resistance Min. 1 Mz 5 Defective work equip- ment and pump controller aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting.

C02 (male) Engine stop switch Voltage Between (8) and chassis ground OFF 20 – 30 V ON Max. 1 V