Kaiyi BR380JG-1E0 — FAILURE CODE [7RGAMA] ABNORMALITY IN 2ND CONVEYOR PRESSURE SENSOR

SEN02091-00 40 Troubleshooting Failure code [7RGAMA] Abnormality in 2nd conveyor pressure sensor 1 38 BR380JG-1E0 User code Failure code Trouble Abnormality in 2nd conveyor pressure sensor (Work equipment and pump controller (work equipment control) system) — 7RGAMA Contents of trouble • Signal voltage from the secondary conveyor pressure sensor is below 0.3 V or above 4.42 V. Action of controller • Mistakes the second conveyor pressure for 0 MPa. (Primary conveyor, crusher, feeder, muck discharge conveyor, magnetic separator and vibratory screen) • When the cause of failure disappears, system is reset by itself.

Problem that appears on machine • Whole work equipment does not stop completely even if abnormal load is applied to the secondary conveyor. • Horn sounds (three intermittent sounding) upon detecting a failure. Related information • Input from the secondary conveyor pressure sensor can be checked with the monitoring function (Code: 24402, 2nd Conv. Pressure). • The failure history is recorded. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective 5 V sensor power supply system If the failure code [DA25KP] is displayed simultaneously, carry out trouble- shooting for it first.

2 Defective secondary conveyor pressure sensor (Internal failure) aPrepare with engine starting switch OFF, then turn engine starting switch ON or START and carry out troubleshooting. S06 (male) Voltage Between (1) and (3) 4.5 – 5.5 V Between (1) and (2) 0.3 – 4.5 V If the voltage is abnormal, replace with another pressure sensor (pressure sensor of magnetic separator etc.) and check if failure codes are dis- played.

(If the E mark of the failure code disappears, the secondary con- veyor pressure sensor is defective.) 3 Disconnection in wir- ing harness (Discon- nection or defective contact in connector) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between C01 (female) (1) – A21 – S06 (female) (2) Resistance Max. 1 z Wiring harness between C01 (female) (4), (10) – A21 – S06 (female) (1) Resistance Max. 1 z Wiring harness between C01 (female) (22) – A21 – S06 (female) (3) Resistance Max.

1 z 4 Grounding fault in wir- ing harness (Contact with ground circuit) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between C01 (female) (1) – A21 – S06 (female) (2) and chassis ground Resistance Min. 1 Mz 5 Hot short in wiring har- ness (Contact with 24V circuit) aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. Wiring harness between C01 (female) (1) – A21 – S06 (female) (2) and chassis ground Voltage Max. 1 V Wiring harness between C01 (female) (22) – A21 – S06 (female) (3) and chassis ground Voltage Max.

5 V 6 Defective work equip- ment and pump controller aIf causes 1 – 5 are not detected, work equipment and pump controller may be defective. (Since trouble is in system, troubleshooting cannot be carried out.)