SEN02091-00 40 Troubleshooting Failure code [7RJAKA] Disconnection in travel lock EPC solenoid valve 1 40 BR380JG-1E0 User code Failure code Trouble Disconnection in travel lock EPC solenoid valve (Work equipment and pump controller (work equipment control) system) — 7RJAKA Contents of trouble • When the travel lock EPC valve solenoid is driven, disconnection of the circuit is detected. Action of controller • Turns the output to the travel lock EPC valve solenoid OFF. • Even if cause of failure disappears, system does not reset itself until engine starting switch is turned OFF. Problem that appears on machine • The machine does not travel.
• Horn sounds (three intermittent sounding) upon detecting a failure. Related information • The drive current of the travel lock EPC valve can be checked with the monitoring function (Code: 28801, Travel Lock EPC Curr.) • Since the controller detects a disconnection when the solenoid output is ON, turn the output ON for reproduction check after recovery. • The failure history is recorded. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective travel lock EPC valve solenoid (Internal disconnec- tion) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON.
V11 (male) Resistance Between (1) and (2) 7 – 14 z 2 Defective travel diffuse switch aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. B38 (male) Travel diffuse switch Resistance Between (1) and (3) Normal Max. 1 z Emergency Min. 1 Mz Between (6) and (8) Normal Max. 1 z Emergency Min. 1 Mz 3 Disconnection in wir- ing harness (Discon- nection in wiring or defective contact in connector) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between C03 (female) (35) and B38 (female) (1) Resistance Max.
1 z Wiring harness between B38 (female) (3) and V11 (female) (2) Resistance Max. 1 z Wiring harness between B38 (female) (8) and V11 (female) (1) Resistance Max. 1 z Wiring harness between B38 (female) (6) and C03 (female) (13), (23) Resistance Max. 1 z 4 Defective work equip- ment and pump controller aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. C03 (female) Resistance Between (35) and (13), (23) 7 – 14 z