SEN02091-00 40 Troubleshooting Failure code [7RJAKB] Short circuit in travel lock EPC solenoid valve 1 42 BR380JG-1E0 User code Failure code Trouble Short circuit in travel lock EPC solenoid valve (Work equipment and pump controller (work equipment control) system) — 7RJAKB Contents of trouble • When the travel lock EPC valve solenoid is driven, ground short circuit is detected. Action of controller • Turns the output to the travel lock EPC valve solenoid OFF. • Even if cause of failure disappears, system does not reset itself until engine starting switch is turned OFF. Problem that appears on machine • The machine does not travel.
• Horn sounds (three intermittent sounding) upon detecting a failure. Related information • The drive current of the travel lock EPC valve solenoid can be checked with the monitoring function (Code: 28801, Travel Lock EPC Curr.) • Since the controller detects short circuit when the EPC valve is driven, drive the EPC valve for reproduction check after recovery. • The failure history is recorded.
Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective travel lock EPC valve solenoid (Internal short circuit or grounding fault) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. V11 (male) Resistance Between (1) and (2) 7 – 14 z Between (1) and chassis ground Min. 1 Mz 2 Defective travel diffuse switch aPrepare with engine starting switch OFF and travel diffuse switch Nor- mal, then carry out troubleshooting without turning engine starting switch ON. B38 (male) Resistance Between (1), (3) and (10) Min. 1 Mz Between (1), (3) and chassis ground Min.
1 Mz 3 Grounding fault in wir- ing harness (Contact with ground circuit) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between C03 (female) (35) – B38 (female) (1) and chassis ground Resistance Min. 1 Mz 4 Defective work equip- ment and pump controller aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. C03 (female) Resistance Between (35) and (13), (23) 7 – 14 z Between (35) and chassis ground Min. 1 Mz