SEN02092-00 40 Troubleshooting Failure code [CA123] Charge pressure sensor too low 1 14 BR380JG-1E0 User code Failure code Trouble Charge pressure sensor too low (Engine controller system) E11 CA123 Contents of trouble • Pressure signal circuit of boost pressure/temperature sensor detected low voltage. Action of controller • Fixes charge pressure value and continues operation. Problem that appears on machine • Engine output lowers. Related information • Signal voltage on boost pressure side of boost pressure/temperature sensor can be checked with monitoring function. (Code: 36501, Charge Press Sens Volt) • Method of reproducing failure code: Turn starting switch ON.
Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective sensor power supply 2 system If failure code [CA187] is also indicated, carry out troubleshooting for it first. 2 Defective boost pres- sure/temperature sen- sor [pressure signal system] aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. BOOST PRESS & IMT Voltage Between (2) – (4) Power supply 4.75 – 5.25 V Voltage is measured with wiring harness connected. Accordingly, if voltage is abnormal, check wiring harness and controller, too, for another cause of trouble, and then judge.
3 Ground fault in wiring harness (Short circuit with GND circuit) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE01 (female) (44) – BOOST PRESS & IMT (female) (1) Resistance Min. 100 kz 4 Short circuit in wiring harness (with another wiring harness) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE01 (female) (44) – BOOST PRESS & IMT (female) (1) and between CE01 (female) (47) – JC02 – BOOST PRESS & IMT (female) (4) Resistance Min.
100 kz 5 Defective wiring har- ness connector Connecting parts between boost pressure/temperature sensor – engine wiring harness – engine controller may be defective. Check them directly. • Looseness of connector, breakage of lock, or breakage of seal • Corrosion, bend, breakage, push-in, or expansion of pin • Moisture or dirt in connector or defective insulation 6 Defective engine controller aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. CE01 Voltage Between (37) – (47) Power supply 4.75 – 5.25 V