SEN02092-00 40 Troubleshooting Failure code [CA131] Throttle sensor too high 1 16 BR380JG-1E0 User code Failure code Trouble Throttle sensor too high (Engine controller system) E14 CA131 Contents of trouble • Signal circuit of fuel control dial detected high voltage. Action of controller • If trouble occurs while starting switch is in ON position, controller fixes voltage value to level just before detection of trouble and continues operation. • If starting switch is turned ON while voltage is abnormally high, controller continues operation with voltage at 100% value. Problem that appears on machine • Engine speed cannot be controlled with fuel control dial.
Related information • Signal voltage of fuel control dial can be checked with monitoring function. (Code: 03000, Fuel Dial Pos Sens Volt) • Method of reproducing failure code: Turn starting switch ON. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective throttle sen- sor power supply sys- tem If failure code [CA2185] is also indicated, carry out troubleshooting for it first. 2 Defective fuel control dial aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. P10 Voltage Between (1) – (3) Power supply 4.75 – 5.25 V Voltage is measured with wiring harness connected.
Accordingly, if voltage is abnormal, check wiring harness and controller, too, for another cause of trouble, and then judge. 3 Hot short (Short circuit with 5 V/24 V circuit) in wiring harness aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. Wiring harness between CE02 (female) (9) – P10 (female) (2) Voltage Max. 1 V 4 Short circuit in wiring harness (with another wiring harness) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE02 (female) (9) – P10 (female) (2) and between CE02 (female) (22) – P10 (female) (1) Resistance Min.
100 kz 5 Defective wiring har- ness connector Connecting parts between fuel control dial – machine wiring harness – engine controller may be defective. Check them directly. • Looseness of connector, breakage of lock, or breakage of seal • Corrosion, bend, breakage, push-in, or expansion of pin • Moisture or dirt in connector or defective insulation 6 Defective engine controller aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. CE02 Voltage Between (22) – (23) Power supply 4.75 – 5.25 V