Kaiyi BR380JG-1E0 — FAILURE CODE [CA221] AMBIENT PRESSURE SENSOR TOO HIGH

SEN02092-00 40 Troubleshooting Failure code [CA221] Ambient pressure sensor too high 1 32 BR380JG-1E0 User code Failure code Trouble Ambient pressure sensor too high (Engine controller system) E11 CA221 Contents of trouble • High voltage was detected in signal circuit of ambient pressure sensor. Action of controller • Fixes ambient pressure value and continues operation. Problem that appears on machine • Engine does not start easily. • Engine output lowers. Related information • Signal voltage of ambient pressure sensor can be checked with monitoring function. (Code: 37401, Ambient Press Sens Volt) • Method of reproducing failure code: Turn starting switch ON.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective sensor power supply 1 system If failure code [CA386] is also indicated, carry out troubleshooting for it first. 2 Defective ambient pressure sensor aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. AMBIENT AIR PRESURE Voltage Between (1) – (2) Power supply 4.75 – 5.25V Voltage is measured with wiring harness connected. Accordingly, if voltage is abnormal, check wiring harness and controller, too, for another cause of trouble, and then judge.

3 Hot short (Short circuit with 5V/24V circuit) in wiring harness aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. Wiring harness between CE01 (female) (3) – AMBIENT AIR PRESSURE (female) (3) Voltage Max. 1 V 4 Short circuit in wiring harness (with another wiring harness) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE01 (female) (3) – AMBIENT AIR PRESSURE (female) (3) and between CE01 (female) (33) – AMBIENT AIR PRESSURE (female) (1) Resistance Min.

100 kz 5 Defective wiring har- ness connector Connecting parts between ambient pressure sensor – engine wiring har- ness – engine controller may be defective. Check them directly. • Looseness of connector, breakage of lock, or breakage of seal • Corrosion, bend, breakage, push-in, or expansion of pin • Moisture or dirt in connector or defective insulation 6 Defective engine controller aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. CE01 Voltage Between (33) – (38) Voltage 4.75 – 5.25 V