SEN02092-00 40 Troubleshooting Failure code [CA324] Disconnection or short circuit in injector No.3 1 46 BR380JG-1E0 User code Failure code Trouble Disconnection or short circuit in injector No.3 (Engine controller system) E11 CA324 Contents of trouble • Opening or short circuit was detected in drive circuit of No. 3 injector. Action of controller • None in particular. Problem that appears on machine • Combustion becomes irregular or engine hunts. • Engine output lowers. Related information • Method of reproducing failure code: Start engine. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective No.
3 injector aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. INJ CYL 3 (male) Resistance Between (1) – (2) Max. 2 z Between (1) – chassis ground Min. 100 kz 2 Disconnection in wir- ing harness (Discon- nection in wiring or defective contact in connector) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE01 (female) (55) – INJ CYL 3 (female) (1) Resistance Max. 2 z Wiring harness between CE01 (female) (52) – INJ CYL 3 (female) (2) Resistance Max.
2 z 3 Ground fault in wiring harness (Short circuit with GND circuit) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE01 (female) (55) – INJ CYL 3 (female) (1) Resistance Max. 2 z 4 Short circuit in wiring harness (with another wiring harness) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE01 (female) (55) – each of CE01 (female) pins (With all wiring har- ness connectors disconnected) Resistance Min.
100 kz Wiring harness between CE01 (female) (52) – each of CE01 (female) pins (With all wiring har- ness connectors disconnected) Resistance Min. 100 kz 5 Defective wiring har- ness connector Connecting parts between No. 3 injector – engine wiring harness – engine controller may be defective. Check them directly. • Looseness of connector, breakage of lock, or breakage of seal • Corrosion, bend, breakage, push-in, or expansion of pin • Moisture or dirt in connector or defective insulation 6 Defective injector of other cylinder or defec- tive harness If the failure codes related to injector are indicated, carry out troubleshoot- ing for them, too.
7 Defective engine controller aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. CE01 (male) Resistance Between (55) – (52) Max. 2 z Between (55) – chassis ground Min. 100 kz