Kaiyi BR380JG-1E0 — FAILURE CODE [CA452] COMMON RAIL PRESSURE SENSOR TOO LOW

SEN02093-00 40 Troubleshooting Failure code [CA452] Common rail pressure sensor too low 1 24 BR380JG-1E0 User code Failure code Trouble Common rail pressure sensor too low (Engine controller system) E11 CA452 Contents of trouble • There is low voltage in signal circuit of common rail pressure sensor. Action of controller • Limits output and continues operation. Problem that appears on machine • Engine does not start. • Engine speed or output lowers. Related information • Signal voltage of common rail pressure sensor can be checked with monitoring function. (Code: 36401, Rail Pressure Sens Volt) • Method of reproducing failure code: Turn starting switch ON.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective sensor power supply 2 system If failure code [CA187] is also displayed, carry out troubleshooting for it first. 2 Defective common rail pressure sensor aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. FUEL RAIL PRESS Voltage Between (3) – (1) Power supply 4.75 – 5.25 V Voltage is measured with wiring harness connected. Accordingly, if voltage is abnormal, check wiring harness and controller, too, for another cause of trouble, and then judge.

3 Ground fault in wiring harness (Short circuit with GND circuit) aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. Wiring harness between CE01 (female) (25) – FUEL RAIL PRESS (female) (2) Resistance Min. 100 kz 4 Short circuit in wiring harness (with another wiring harness) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE01 (female) (25) – FUEL RAIL PRESS (female) (2) and between CE01 (female) (47) – JC02 – FUEL RAIL PRESS (female) (1) Resistance Min.

100 kz 5 Defective wiring harness connector Connecting parts between common rail pressure sensor – engine wiring harness – engine controller may be defective. Check them directly. • Looseness of connector, breakage of lock, or breakage of seal • Corrosion, bend, breakage, push-in, or expansion of pin • Moisture or dirt in connector or defective insulation 6 Defective engine controller aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. CE01 Voltage Between (37) – (47) Power supply 4.75 – 5.25 V