Kaiyi BR380JG-1E0 — FAILURE CODE [CA778] ABNORMALITY IN ENGINE BKUP SPEED SENSOR

SEN02093-00 40 Troubleshooting Failure code [CA778] Abnormality in engine Bkup speed sensor 1 34 BR380JG-1E0 User code Failure code Trouble Abnormality in engine Bkup speed sensor (Engine controller system) E15 CA778 Contents of trouble • There is error in signal from engine Bkup speed sensor. Action of controller • Continues control with signal from engine Ne speed sensor. Problem that appears on machine • Engine does not start easily. • Engine output lowers. Related information • Method of reproducing failure code: Start engine.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective sensor power supply 2 system If failure code [CA187] is also displayed, carry out troubleshooting for it first. 2 Defective engine Bkup speed sensor aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. CAM SENSOR Voltage Between (1) – (2) Power supply 4.75 – 5.25 V Voltage is measured with wiring harness connected. Accordingly, if voltage is abnormal, check wiring harness and controller, too, for another cause of trouble, and then judge.

3 Breakage or improper clearance of engine Bkup speed sensor Engine Bkup speed sensor may be broken or may have improper clear- ance. Check it directly. 4 Breakage of rotation sensor ring Rotation sensor ring may be broken. Check it directly. 5 Disconnection in wiring harness (Disconnec- tion in wiring or defec- tive contact in connector) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE01 (female) (26) – CAM SENSOR (female) (3) Resistance Max.

10 z 6 Ground fault in wiring harness (Short circuit with GND circuit) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE01 (female) (26) – CAM SENSOR (female) (3) Resistance Min. 100 kz 7 Hot short (Short circuit with 5V/24V circuit) in wiring harness aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. Wiring harness between CE01 (female) (26) – CAM SENSOR (female) (3) Voltage Max.

1 V 8 Short circuit in wiring harness (with another wiring harness) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE01 (female) (26) – CAM SENSOR (female) (3) or between CE01 (female) (37) – JC01 – CAM SENSOR (female) (1) Resistance Min. 100 kz Wiring harness between CE01 (female) (26) – CAM SENSOR (female) (3) or between CE01 (female) (47) – JC02 – CAM SENSOR (female) (2) Resistance Min. 100 kz