Kaiyi BR380JG-1E0 — FAILURE CODE [CA2311] ABNORMAL RESISTANCE IN PUMP REGULATOR VALVE

SEN02093-00 40 Troubleshooting Failure code [CA2311] Abnormal resistance in pump regulator valve 1 42 BR380JG-1E0 User code Failure code Trouble Abnormal resistance in pump regulator valve (Engine controller system) E11 CA2311 Contents of trouble • Resistance of supply pump actuator circuit is abnormally high or low. Action of controller • None in particular. Problem that appears on machine • Engine output lowers. Related information • Method of reproducing failure code: Start engine.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defect in related sys- tem If another failure code is displayed, carry out troubleshooting for it. 2 Defective supply pump actuator aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. CP3 PUMP REGULATOR (male) Resistance Between (1) – (2) Max. 5 z Between (1) – chassis ground Min. 100 kz 3 Disconnection in wiring harness (Disconnec- tion in wiring or defec- tive contact in connector) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON.

Wiring harness between CE01 (female) (2) – CP3 PUMP REGULATOR (female) (1) Resistance Max. 5 z Wiring harness between CE01 (female) (32) – CP3 PUMP REGULATOR (female) (2) Resistance Max. 5 z 4 Ground fault in wiring harness (Short circuit with GND circuit) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE01 (female) (2) – CP3 PUMP REGULATOR (female) (1) Resistance Min. 100 kz 5 Defective wiring harness connector Connecting parts between supply pump actuator – engine wiring harness – engine controller may be defective. Check them directly.

• Looseness of connector, breakage of lock, or breakage of seal • Corrosion, bend, breakage, push-in, or expansion of pin • Moisture or dirt in connector or defective insulation 6 Defective engine controller aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. CE01 (male) Resistance Between (2) – (32) Max. 5 z Between (2) – chassis ground Min. 100 kz