SEN02093-00 40 Troubleshooting Failure code [CA2556] Short circuit in air intake heater relay 1 46 BR380JG-1E0 User code Failure code Trouble Short circuit in air intake heater relay (Engine controller system) E15 CA2556 Contents of trouble • Short circuit was detected in drive circuit of intake air heater relay. Action of controller • None in particular. Problem that appears on machine • Intake air heater does not work (Engine does not start easily and exhaust gas becomes white at low temperature). Related information • Method of reproducing failure code: Turn starting switch ON when engine coolant temperature is below –4°C.
Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective air intake heater relay (Internal disconnection) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. (Troubleshooting for relay unit) R18 (male) Resistance Between (1) – (2) 300 – 600 z aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. (Troubleshooting by replace- ment) Replace automatic preheater relay (R18)) with another relay and perform reproducing operation. If “E” of failure code goes off at this time, replaced relay is defective.
2 Ground fault in wiring harness (Short circuit with GND circuit) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE02 (female) (40) – R18 (female) (1) Resistance Min. 100 kz 3 Short circuit in wiring harness (with another wiring harness) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE02 (female) (40) – each of CE02 (female) pins (With R18 discon- nected) Resistance Min.
100 kz 4 Defective wiring harness connector Connecting parts between automatic preheater relay – machine wiring harness – engine controller may be defective. Check them directly. • Looseness of connector, breakage of lock, or breakage of seal • Corrosion, bend, breakage, push-in, or expansion of pin • Moisture or dirt in connector or defective insulation 5 Defective engine controller aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. CE02 (male) Resistance Between (40) – (42) 300 – 600 z