SEN02094-00 40 Troubleshooting Failure code [DA2SKQ] Abnormality in model code input 1 16 BR380JG-1E0 User code Failure code Trouble Abnormality in model code input (Work equipment and pump controller (pump control) system) — DA2SKQ Contents of trouble • Model code signal for other model than registered in the controller is input. Action of controller • Mistakes the model for BR380JG-1E0. • Changes the optional setting to initial setting when the machine model selection is changed. • Even if cause of failure disappears, system does not reset itself until engine starting switch is turned OFF.
Problem that appears on machine • Horn sounds upon detecting a failure (three intermittent sounding, work equipment is still operable). Related information • The failure history is recorded. • The operator can carry out operation of the work equipment. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective model selec- tion connector aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between A24 (male) (1) and (2) Resistance Max. 1 z Wiring harness between A24 (male) (1) and (3), (4) Resistance Min.
1 Mz 2 Disconnection in wiring harness (Disconnection or defective contact in connector) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between C02 (female) (7) and A24 (female) (3) Resistance Max. 1 z Wiring harness between C02 (female) (17) and A24 (female) (2) Resistance Max. 1 z Between A24 (female) (1) and chassis ground Resistance Max. 1 z 3 Grounding fault in wir- ing harness (Contact with ground circuit) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON.
Wiring harness between C02 (female) (7) – A24 (male) (3) and chassis ground Resistance Min. 1 Mz Wiring harness between C02 (female) (17) – A24 (male) (2) and chassis ground Resistance Min. 1 Mz 4 Hot short in wiring har- ness (Contact with 24 V cir- cuit) aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting Between C02 (female) (7) and chassis ground Voltage Max. 1 V Between C02 (female) (17) and chassis ground Voltage Max. 9 V 5 Defective work equip- ment and pump con- troller If causes 1 – 4 are not detected, work equipment and pump controller may be defective. (Since trouble is in system, troubleshooting cannot be car- ried out.)