Kaiyi BR380JG-1E0 — E-2 THE ENGINE STOPS WHILE IT IS RUNNING

SEN02095-00 40 Troubleshooting E-2 The engine stops while it is running 1 8 BR380JG-1E0 Trouble • The engine stops while it is running. Related information • When the engine stop switch (or radio controller all stop switch) is operated, the machine monitor displays “Engine stopped” for about 10 seconds. • If failure code [DDA6KA] is displayed when the key is ON, carry out troubleshooting for it.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Disconnection in ACC line (Defective contact in connector or loose- ness of round terminal screw) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. CE02 (female) Starting switch Voltage Between (39) – chassis ground OFF Max. 1 V ACC 20 – 30 V 2 Defective fuse No. 5 If fuse or fusible link is broken, circuit probably has ground fault.

(See cause 6.) 3 Defective engine stop relay R19 or engine stop relay RR05 (with radio controller only) (Internal disconnec- tion or short circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. R19 (male), RR05 (male) Resistance Between (1) – (2) 250 – 350 z Between (3) – (5) Min. 1 Mz Between (3) – (6) Max. 1 z 4 Defective engine stop switch (Internal discon- nection) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Connector Switch Resistance Between B76A (male) (1) – B76B (female) (1) Released Max. 1 z Pressed Min.

1 Mz 5 Disconnection in wiring harness (Disconnec- tion in wiring or defec- tive contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between starting switch ACC – B28 (5) (power supply side) – circuit branch end Resistance Max. 1 z Wiring harness between starting switch ACC – A08 (9) – A11 (7) – B76A (female) (1) Resistance Max. 1 z Wiring harness between B76B (male) (1) – A11 (2) – A08 (6) – C01 (female) (18) Resistance Max. 1 z Wiring harness between B28 (5) – R19 (female) (3) Resistance Max. 1 z Wiring harness between R19 (female) (6) – A05 (9) – CE02 (female) (39) Resistance Max.

1 z 6 Ground fault in wiring harness (Short circuit with GND circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between starting switch ACC – B28 (5) (power supply side) – circuit branch end Resistance Max. 1 z Wiring harness between B28 (5) – R19 (female) (3) Resistance Max. 1 z Wiring harness between R19 (female) (6) – A05 (9) – CE02 (female) (39) Resistance Max. 1 z Wiring harness between R19 (female) (2) – C02 (female) (8) Resistance Max. 1 z Between wiring harness connected to RR05 (female) (2) and chassis ground Resistance Max. 1 z