SEN02095-00 40 Troubleshooting E-7 The machine monitor does not display any item 1 20 BR380JG-1E0 Trouble • When the starting switch is turned ON, the machine monitor does not display any item Related information — Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective fuse No. 1 If fuse is broken, the circuit probably has ground fault. 2 Defective starting switch aPrepare with starting switch OFF, then keep starting switch OFF and ON and carry out troubleshooting in each case. Starting switch Starting switch Resistance Between B – ACC OFF Min. 1 Mz ON Max.
1 z 3 Disconnection in wiring harness (Disconnec- tion in wiring harness or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between P01 (female) (1) (2) – starting switch ACC Resistance Max. 1 z Wiring harness between starting switch B – fuse box B28 (1) Resistance Max. 1 z Wiring harness between P01 (female) (6) (7) – A09 – chassis ground Resistance Max. 1 z Wiring harness between P01 (female) (8) – B28 (2) Resistance Max.
1 z 4 Short circuit with chas- sis ground in wiring harness (Contact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between P01 (female) (1) (2) – starting switch ACC and chassis ground Resistance Min. 1 Mz Wiring harness between starting switch B – fuse box B28 (1) and chassis ground Resistance Min. 1 Mz Wiring harness between P01 (female) (8) – fuse box B28 (2) and chassis ground Resistance Min. 1 Mz 5 Defective machine monitor aPrepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting.
P01 Voltage, Resistance Between (1) (2) – chassis ground 20 – 30 V Between (6) (7) – chassis ground Min. 1 Mz Between (8) – chassis ground 20 – 30 V